THE ROOTS

12 Mic/Line Inputs

8 Line Outputs

64x64 Dante IO

We use the DSP to route and control audio being sent to our different sets on Control Room Reference Monitors

The NS-10 is an 8-ohm two-way loudspeaker with a 10.4-litre sealed cabinet measuring 382 × 215 × 199 millimetres (15.0 × 8.5 × 7.8 in) and weighing 6 kilograms (13.2 lb).[5][4] Its 2.5 cm (0.98 in) particle-board cabinet has a wood veneer skin with seven black finishing layers. The domestic version of the speaker was vertically oriented, and came factory fitted with a grille.[6][5]

Its two drivers are a 180 mm paper woofer and a 35 mm soft-domed tweeter.[5][4] The woofer's diaphragm, weighing 3.7 g, is manufactured from a flat sheet of pressed pulp paper. Unconventionally, it is formed into conical shape not through moulding or pressure, but by curling and then gluing the two ends together.[5] Against the black finish of the cabinet, the white bass/mid driver cone is a distinctive and iconic feature of the product.[6][5]

The network is second-order passive, crossing over at 2 kHz. The frequency range is quoted from 60 Hz to 20 kHz, and rated power handling is 25–50 W.[5][4] The early version of the speaker has press-down type input terminals; later models had screw terminals.

10-inch glass-composite low-frequency transducer

250 watt, Class AB biamplification

Input gain control (-30 dB to +6 dB, continuously variable) and continuously variable lowpass filter (50 Hz to 130 Hz)

Switchable highpass filter removes frequency content below 80 Hz from the full-range signal sent to the main monitors

Momentary footswitch (included) bypasses the subwoofer, highpass filter, and Sub Out

2-way acoustic-suspension speaker system

9 cm cone woofer & 2.5 cm tweeter

2-way acoustic-suspension speaker system

2- 9 cm cone woofers & 1- 2.5 cm tweeter